Skrab

The G 1/2" Machine Manual Tap is used to calibrate and thread blind holes and throughholes on the machine in a single pass. The recommended hole diameter is 19 mm...

The G 1/4" machine-manual tap is used to calibrate and create threads in blind and through-holes on the machine in a single pass. The recommended hole diameter is 11.8 mm...

..

A set of two M10 x 1.5 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 8.5 mm. The first tap, rough, has cut tooth tops, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

The M10 x 1.0 machine-manual tap is used to calibrate and create threads in blind and through-holes on the machine in a single pass. The recommended hole diameter is 9.0 mm...

A set of two M10 x 1.0 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 9.0 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

A set of two M10 x 1.25 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 8.8 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elo..

The M10 x 1.25 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in a single pass. The recommended bore diameter is 8.8 mm...

A set of two M10 x 1.25 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 8.8 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elo..

A set of two M12 x 1.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 10.2 mm. The first tap, rough, has cut tooth tops, the outer diameter is smaller. The second, finishing, with short tooth segments, has el..

The M12 x 1.0 machine-manual tap is used to calibrate and create threads in blind and through-holes on the machine in a single pass. The recommended hole diameter is 11.0 mm...

A set of two M12 x 1.25 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 10.8 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has el..