Skrab

The M12 x 1.5 machine-manual tap is used to calibrate and create threads in blind and through-holes on the machine in a single pass. The recommended hole diameter is 10.5 mm...

A set of two M12 x 1.5 taps is used to calibrate and create threads in blind and through holes manually using a special holder. The recommended bore diameter is 10.5 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elo..

The M14 x 1.5 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in a single pass. The recommended hole diameter is 12.5 mm...

A set of two M14 x 1.5 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 12.5 mm. The first tap, rough, has cut tooth tops, the outer diameter is smaller. The second, finishing, with short tooth segments, has elo..

The M16 x 2.0 machine-manual tap is used to calibrate and create threads in blind and through-holes on the machine in a single pass. The recommended bore diameter is 14.0 mm...

..

The M16 x 1.5 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in a single pass. The recommended hole diameter is 14.5 mm...

A set of two M22 x 2.5 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 19.5 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elo..

The M4 x 0.7 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in one pass. The recommended hole diameter is 3.3 mm...

A set of two M4 x 0.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 3.3 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

A set of two M4 x 0.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 3.3 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

A set of two M5 x 0.8 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 4.2 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..